I was doing some local wheeling today and I started to hear a pinging noise when I came to a stop and shifted from reverse to drive. I figured it was a u-joint, no problem I always bring spare complete drive shafts with me. So I started the shake down, joints were all fine. but after stareing at it long enough I noticed the slip yoke eliminator flange that bolts to the flange on my t case was missing a bolt and the other 3 were loose. So I tightened them down and replaced the missing one. no luck still gotta ping, So tomarrow I'm gona take the shaft off and see if the nut holding the flange to the t case is loose or if my output shaft support bearing is all spanked out...or worse.
2 posters
Possible Snag for Saterday
N8sBroncoMI- Posts : 63
Join date : 2009-05-16
Age : 35
Location : Bridgman / Marquette MI
Waychoff05- Posts : 90
Join date : 2009-05-16
Age : 37
Location : Allegan
well good luck!! Hope you can get her back and going!!
N8sBroncoMI- Posts : 63
Join date : 2009-05-16
Age : 35
Location : Bridgman / Marquette MI
fixxed!!! the flange that bolts to the output on my t-case as loose as h#!!. Got the beast all fixed and ready to ride!
Waychoff05- Posts : 90
Join date : 2009-05-16
Age : 37
Location : Allegan
N8sBroncoMI wrote:fixxed!!! the flange that bolts to the output on my t-case as loose as h#!!. Got the beast all fixed and ready to ride!
That's good!!
|
|
|
» run after the meeting Saturday
» ps2 / 4-5 games / 2 controlers / 2 mem cards
» Club Store
» Forum Problems?
» 4x4 club
» The xj is broke again
» BADLANDS AUG. 22-23
» Sundowners Rodeo